windows 10 and j1sys

lizardking

IT IS STILL ALL BENS FAULT
Joined
Dec 26, 2014
Messages
416
Location
Gold Coast
ok has anyone had anyproblem using the J1SYS UBL on windows 10 i can get the p2 to connect via usb cable and able to change IP and do everything else but i can not get it to see IP address
 

scamper

Dedicated elf
Joined
Jan 5, 2014
Messages
1,225
Location
collie
I am no computer expert, but I think from memory you need to change the ip range that your computer "see's"
ie. the normal range is something like 192.168.x.x and you need to add 10.10.x.x
There was a discussion about this in the networking section on this forum a while back.
 

Benslights

Dedicated elf
Joined
May 2, 2010
Messages
2,868
Location
Elderslie
interesting. today I try logging into my bbb and can not I can ping it and see it in netscan but can not access it. only last night I had no issue wonder if it is the same thing
 

lizardking

IT IS STILL ALL BENS FAULT
Joined
Dec 26, 2014
Messages
416
Location
Gold Coast
BensChristmasLights said:
interesting. today I try logging into my bbb and can not I can ping it and see it in netscan but can not access it. only last night I had no issue wonder if it is the same thing
this is what i was talking about apparently they dont like some networks its a PITA
 
Top