needing somone adavtek savy.. my display is looking nothing like it should look.
im using a rpi3B+ with fpp and 2 pixlite controllers.
i updated fpp and its hasnt been the same since. not to sure where i went wrong. i went back over all the stuff in the advatek assistant and in the advanced...
i was using the fpp test page, ill do a further investigation tomorrow, and double check everything.. what is meant by "pushed your model data with fpp"
ill have to check tomorrow havent looked at that for the last few seasons as its a pain have to connect them to the router and change ip adress on them to get access to them
Do I have some sort of funky Channel over lapping issue? Don’t remember having this issue last year? Haven’t done any repairs or changed anything from last year (same layout and same controller ouputs) other then updated fpp. When on full red, green and blue on the test page I get some strange...
Do I need my controllers ip set up to be on my inside router like as if would if I were to set it all up manually or can I have it on the same ip that my rpi (with fpp) talks to them on and fpp will take care of it??
if that makes sense
hey guys could i get someone to just run there eyes over these screen shots to make sure im on the right track.. (currently battleing a new born and 2 yr old and its all escaped my brain)..
im most concerned about the pages from the advatek assistant cant remember if i had to punch in the start...
Hey guys I need to access my controllers to modify the pixel out put numbers, last year I connected to the controllers via my router and advatek assistant and the controllers would pop up when after searching for them, this year when I try I to search neither of them pop up, not sure if I’m...