Many options but for my mega tree I used an old Hill Hoist clothes line I had laying around for the support (replaced the rising pole to be longer), topper from a seller on here, 180 degree bent tube made up for the base, 5v pixel lights and pixel strip to give 24 strands of 50 lights each. The...
Is it an old star/design that was changed for this year? Have you uploaded to the F16v4?
I changed some elements this year and couldn't get it all working correctly (only half the roof outline would light up). Then it finally twigged, I changed it in xlights and forgot to upload it to the...
Hi All,
After some ideas on how to attach lights to second floor windows. A couple of ideas I have are to mount conduit clips and make a frame or the other is to glue magnets to the window frame and once again make a frame. Looking for the safest option for install/removal.
Are there any...
I have two of the below in my setup currently with cable glands on the side. Big enough to house a power supply, Falcon smart receiver and a power distro board. Clam vent each end and a 5v fan inside to help with heat extraction. So far so good with no water inside...
With the new day brings wisdom, or perhaps just showing my mistakes from the day before :unsure:. Found the issue this morning. Seem the cable I was using for the first prop was in fact an end cable. Data doesn't go in the data out end O_O. I have now removed the green wire so I don't make...
Hi Again all, Another issue (or sanity check) I hope someone can assist with, or see if I have a something incorrect (if I can explain it correctly).
Setup: F16v4 with differential expansion board and two smart receivers (third yet to be added). Configured to 16 local ports and 4 smart...
Hi all, Busy putting together my display (first year) and I have come across this issue (which I assume is my setup) but I can't seem to figure it out yet. I have a mega tree and spirals on the main falcon controller (F16v4); arches and Dalek trees on the first expansion board (two more to add...
Only being new to this I had some issues myself. I think by looking at you tree configuration it doesn't look correct. For my 24 strand x 50 pixel tree I have the following setup (split over 4 ports).
Strings = 4
Nodes = 300
Strands = 6
So by my thinking yours should be:
Strings = 2
Nodes =...