This looks great! Would you share your pattern for pixel placement, or your XLights model info? I'm printing this now. Thanks!
Like you, I like to print what I can. It helps justify the purchase of the printer.
Brad, I use Afinia software to print, and for the life of me can't figure out how to flip or rotate the corner to get the other side. Can you post an stl of the other side please?
Brad, would you revise Phil's original brackets adding the hole for the plastic pin? Especially the center bracket. I keep forgetting I need to cut off those darn things!
I found the BBB Mounting holes were too large. They lined up perfectly, but the M3 screws didn't bite at all. I just filled them with extruded Plastic, and drilled.
I promised I would post a picture of my matrix assembled with the 3D printed brackets. Here it is. 30 panels.
https://www.dropbox.com/sc/yvhc8fcvnfmdh2w/AADD4y2PxgWbTzGAMFpG8qaGa
Contrary to Phil's statement above about not being able to print the larger items on a small bed machine, I was able to print all of the on my Afinia 470 by rotating the object 45 degrees, then tweaking the position on the bed a little. All of them line up on the panels perfectly! Thanks again...