Running Firmware v1.4.8
Bank 1, 5v in and all outputs are working fine.
Bank 2, 12v and the Advatek Assistance says "Bank 2: Off". I've put a meter to the power supply, Bank 2, the connectors on the board and at the pigtails, all reads 11.xx. So it getting power. (Note, this is the same...
Has anyone been able to get power supply and a Pixlite 16 into A single CG-1500? If you have, do you have a picture of how you ran you cables to get everything to fit (if it's possible)?
Thanks Devo, that gives me an estimate on where to start testing and see from there what I need. My pixels are the 2811 (mix of 5v and 12v) will be using 14 out to the first pixel and then 16 guage when I need to connect the next string. Thanks again!
I was wondering if there are any additional videos (YouTube or Vimeo) out there on how to use the Advance String Configuration set up? Other than the Advatek website or HolidayCoro (I've watched those several times and not getting what I think I need out of it).
Here is what I'm trying to do...