Thanks Phil. The only mistake was that I numbered the RJ45 pins backward. You verify it when you make the part, then just assume that it's right. :-[
I was working on this until 10:00pm the night before I was to show it off at a mini in the morning. I had a dead micro in the middle but...
I think it works just fine. I use it fairly often for prototype work.
In my mind, a prototype is something you make quickly and far from perfect. You can make very accurate boards if you want to put in a lot of time. The way that you’re suppose to do this is make a first pass with a...
Been around for awhile on several other Christmas boards, so one more to kill time on couldn't hurt. :)
I'm a DIY kind of guy and make most of my electonic hardware, though I do have a couple of LOR controllers.
I see a few familiar friends here and hope to make a few more.
Ernie
I use the 7000 model at work. http://www.t-tech.com/products/models.asp
It's specifically for PC boards so it has limited Z axis capability.
AFAIK I'm the only one that uses it. It's occasionally made some my Christmas stuff too. ;D