Recent content by Jeff

Thanks for all the suggestions up to this point. I know its not easy trying to help someone troubleshoot without getting your hands on it. I really appreciate all the help. So as of now I have re-flashed the firmware to v3.3 and made sure the ASIC Info was 3.3 LP035 for both ports. Universe...

Yes I made the changes to the P12s as superman suggested. The intervals have been changed to 30, clear cnt = 0, total cnt = 0 and initial universe size is 512.

Superman, I was re-soldered the 27ch board and only used single wires this time with the 568b standard. I was doubling up so I could use it for a DMX in/out, but switched to single wire just to see if I can get this thing going. I also changed the P12S board settings to 30,0,0,512 as you...

Sorry guys, I was out of town for a couple of days and couldn't get the configs sooner. Here are some screen shots for the P12S config and also how i soldered the cat5 wires to the 27 channel DMX controller.

On my P12S I firmware v3.3 and have configured the DMX outputs as Universes 13/14. I have a standard cat5e cable connected to an RJ-45 jack that is wired directly to an Easy 27 channel DMX controller. The DMX controller is not receiving a DMX signal from the P12s and the NIC isn't lit on the...

Awesome everyone, thanks for your help. I went ahead and purchased a 27 channel dmx controller to connect up to the rj45 Jack and plan on seeing it up as universe 13. I'll let everyone know how it goes. The new controller sboil be here in a few days. Thanks again.

You are correct, I guess I am confusing things. I have a few WS2811 pixels nodes and strips that I will be running off the ECG-P12S. I have that part working, but I am looking for a way to convert from the ECG-P12S to dumb rgb elements. Guess I'm just confused on how to run the dumb rgb...

I'm new to this and just purchased a ECG-P12S controller to start off. Question... since I'm new and will have extra space available on my controller, is it possible to run dumb rgb pixel modules directly off of the ECG-P12S controller, or do I need to purchase dmx controllers in order to run...

First of all this forum is a wealth of information and all the guides are awesome, especially for a newbie like me. This is my first time trying anything with RGB pixels or light sequences for that matter. Any help would be much appreciated, so I can stop pulling my hair out. I purchased a...