I reflashed the P12S board with firmware 3.4b and then all outputs were dead. I reflashed again just incase I made a mistake but still all dead.
Strangely, the ASIC version numbers on the System Information web page were all zeros.
So I flashed 3.4 instead and now all outputs work. I am...
I reflashed the P12S board with your copy of 3.4b and then all outputs were dead. I reflashed again just incase I made a mistake but still all dead.
Strangely, the ASIC version numbers on the System Information web page were all zeros.
So I flashed 3.4 instead and now all outputs work. I am...
Has anyone run into an issue with an ECG-P12S/P12D combo board set where there is no data on the second six outputs?
I reflashed the board from 3.4 to 3.4b and now all the outputs are dead. :-(
-Tom
Yes, thanks for making the firmware available. I connected a P12S / P12D board combo tonight but only the first six output work. It has the 3.4 firmware.
Hoping the 3.4b firmware will correct this.
There is not really any passive cooling other than the hardboard the array is mounted on, which is not much of a heat sink.
Although, it has less trouble with heat when vertical. This is because the components on the back have some place for their heat to go. When laying flat the back...
Unfortunately, the acrylic panels I am using look good but tend to bow out slightly when set the panel up vertically. This makes the center pixels appear to be more fuzzy.
I have one acrylic panel as a spacer between the LEDs and the diffuser panel. Next I am going to try replacing the spacer...