Recent content by RaMac10

Yes K3 LOL, Darn I'm going to get some sleep.

Yes, I was just going to do that to make it clear the the Jumper is the K2 1-2,3-4, and that gives 7V - 40V regulated input voltage. Thank you.

Thank you, the video is very good and hope to see more like that. I always Mesure twice (three times) and just cut once. ;)

Yes, I understand, I have a 12VDC system. So there is no specific setting on the Board for 12VDC input to K1. (just regulated 7v - 40v. K1 Jumper 1-2,3-4) There is the 12V supply into K1 with 12V out to pixels (in this case do I really want to power my strips from P2 12v) when I can just hook...

Hello, I now have a P2, Power Supply From Ray Wu 12VDC 350 Watt, and A strip of 5050, IC 2811, 150 chnls. My question is this: Should I Jumper K1 1-2, 3-4 and Leaving all others OPEN and power my strip from the power supply. It would be like the P2 video, set up but with 12V (7V - 40V) vice...

Hello, been sending emails TO J1SYS. I Would like to order some equipment. Hope all is OK