Recent Activity

Activity stream for all registered members at AusChristmasLighting.

  1. Ellis submitted a new display video Greatest Show - xLights ATW

    Dec 11, 2018 at 3:41 PM
  2. Daniel1973 replied to the thread Pixicle Holder (total noob).

    have you tried Thingiverse https://www.thingiverse.com/search?q=pixel+holder&dwh=375c0f1f64245ec

    Dec 11, 2018 at 1:23 PM
  3. droidsteve posted a new thread.

    Pixicle Holder (total noob)

    Say a mention of a 3d printed Pixicle holder, but I can't find it. Is it available? or some DIY on the coro holder? tia

    Forum: Corrugated Plastic (Coro) & 3D Printing

    Dec 11, 2018 at 1:18 PM
  4. beasso81au replied to the thread Closed Falcon F16v3 & F48 E1.31 pixel controller 2018 buy.

    Also interested, in the off chance you have any available still

    Dec 11, 2018 at 1:06 PM
  5. jjBrisvegas replied to the thread Ultra low WS2811 speed.

    I think you will be happier - look forward to the result :-)

    Dec 11, 2018 at 11:35 AM
  6. drakky replied to the thread Ultra low WS2811 speed.

    i ran my p12r at 3200 last year , but am switching to falcon for next year

    Dec 11, 2018 at 11:32 AM
  7. jjBrisvegas replied to the thread Ultra low WS2811 speed.

    Well, I have succumbed to the lure of the Falcon. I have tried the J1Sys ECG-P2, the Pixlite 16, Sans E682 and the Falcon F16v3s and...

    Dec 11, 2018 at 9:49 AM
  8. AJ240 submitted a new display video All I want for Christmas

    Dec 11, 2018 at 9:44 AM
  9. Hexagram replied to the thread Ultra low WS2811 speed.

    Thanks mate that actually does help, I was suspicious that the controller may have been on it's way out given that power cycling it...

    Dec 11, 2018 at 9:44 AM
  10. jjBrisvegas replied to the thread Ultra low WS2811 speed.

    Not a help but I had a similar issue with a J1sys ECG-P2 and newer pixels. I could only run them at 2400 and then they would...

    Dec 11, 2018 at 8:50 AM
  11. ShellNZ replied to the thread Heya all!!!.

    Yep, only 1-3. Currently trying da_tester again just trying to get it to respond to R, G & B. 485 transmitting, however green LED on...

    Dec 11, 2018 at 7:57 AM
  12. JPB replied to the thread Heya all!!!.

    If that green LED on the left side of the board is indicating received data then it does look like it is flickering at the same rate as...

    Dec 11, 2018 at 7:51 AM
  13. ShellNZ posted a new thread.

    Heya all!!!

    Just helping neighbour with his lights this year since Im not having a show. He has some dumbRGB icicles. He has purchased 9 x 30-ch...

    Forum: RGB Lights - Intelligent Pixels and 3-Channel RGB

    Dec 11, 2018 at 7:08 AM
  14. Benslights submitted a new display video sound of silence

    Dec 11, 2018 at 2:12 AM
Loading...