1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

3D Printed J1SYS Controller Mounting plates

Discussion in 'Corrugated Plastic (Coro) & 3D Printing' started by AussiePhil, May 12, 2015.

  1. AussiePhil

    AussiePhil Dedicated Elf Administrator

    Joined:
    Jun 20, 2009
    Messages:
    1,391
    Likes Received:
    0
    Location:
    Canberra, ACT, Australia
    Find Me On:
    At the bottom of this post I will have the attached STL files to enable people with 3D FDM style printers to print their own copies.

    There is three Mounting Plates currently designed
    ECG-P2
    ECG-P12R
    ECG-P12S
    All three designs are in the Zip file.

    I have printed these successfully in ABS using the basic settings of
    Layer height: 0.2mm
    Print Speed: 50mm/sec
    Infill: 10%
    Otherwise use all your preferred slicer settings that give you accurately sized prints.

    Pictures to be inserted.......
     

    Attached Files:

  2. Benschristmaslights

    Benschristmaslights Dedicated Elf Global Moderator Generous Elf

    Joined:
    May 2, 2010
    Messages:
    2,125
    Likes Received:
    7
    Location:
    Elderslie
    Find Me On:

Share This Page