1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

3D Printers

Discussion in 'Corrugated Plastic (Coro) & 3D Printing' started by Noel Richards, Mar 1, 2017.

  1. Noel Richards

    Noel Richards Apprentice Elf

    Joined:
    Dec 16, 2016
    Messages:
    70
    Likes Received:
    3
    Location:
    77 Watkin Ave Woy Woy
  2. heathwithnoteeth

    heathwithnoteeth Full Time Elf Generous Elf

    Joined:
    Aug 23, 2015
    Messages:
    462
    Likes Received:
    31
    Location:
    sheidow park
    i am far from knowing much about them myself...


    but i was looking at getting one of these, reviews seem good, but I'm sure others will have some advice.


    http://www.ebay.com.au/itm/252478576039
     
  3. OP
    OP
    Noel Richards

    Noel Richards Apprentice Elf

    Joined:
    Dec 16, 2016
    Messages:
    70
    Likes Received:
    3
    Location:
    77 Watkin Ave Woy Woy

    Just looked at specs it says XP Win 7 & MacOS - so I have Wind 10.


    Noel
     
  4. heathwithnoteeth

    heathwithnoteeth Full Time Elf Generous Elf

    Joined:
    Aug 23, 2015
    Messages:
    462
    Likes Received:
    31
    Location:
    sheidow park
    i also noticed it is a DIY... so you need to construct it... hmmm
     
  5. battle79

    battle79 Full Time Elf

    Joined:
    Dec 8, 2012
    Messages:
    384
    Likes Received:
    0
    Location:
    Chirnside Park, Victoria, AU
    I have a Wombot that has been very good. Few hiccups with a fan that died and several problems with the user.


    Regards,
    Rowan
     

Share This Page