Adding a new LOR controller - What am I missing

[scotthorwell]

After a interstate relocation, and missing last years show I'm back! Everything has been unpacked in excitement for my new blank canvas, until.......

I've added a new tested controller (CMD24D). Found and works under Hardware Utility, but wont run in Sequence? Works when right click the device in the sequence and "turn on". This is an existing sequence that I've added the device to?

What am I missing / forgotten in my short time away?

 

[AAH]

Has your sequence got the right controller ID setting to suit the new board?
Is your LOR license sufficient to allow you to add the extra 24 channels?
Without seeing any settings it's hard to guess what you've got there.

 

[scotthorwell]

Has your sequence got the right controller ID setting to suit the new board?
Is your LOR license sufficient to allow you to add the extra 24 channels?
Without seeing any settings it's hard to guess what you've got there.

Thanks Alan, i have Pro Version so good for channels.
I've exported the channel config into a new sequence and it works perfectly??? So there is a disconnect somewhere with me adding the controller to a current sequence??

 

[AAH]

I'm no help with that. I haven't used LOR since LOR S3 and haven't configured LOR at all for 12 months and that was on someone elses PC via teamviewer. LOR has changed so much I would just be fumbling these days.