Hey all,
Have connected e682 to a pixel string (correctly I hope), and, via multi-metre testing, see that power comes out near first pixel.
When I try to run the test bed, nothing happens. The manual tells me that the green light should flash and I have not yet seen that happen.
Test pattern 5 has been set up on the config page. But still no test flash. I'm assuming if the green light hasn't flashed this is an error near the board, but I'm not sure what.
Any help would be appreciated.
Mark
Have connected e682 to a pixel string (correctly I hope), and, via multi-metre testing, see that power comes out near first pixel.
When I try to run the test bed, nothing happens. The manual tells me that the green light should flash and I have not yet seen that happen.
Test pattern 5 has been set up on the config page. But still no test flash. I'm assuming if the green light hasn't flashed this is an error near the board, but I'm not sure what.
Any help would be appreciated.
Mark