Only last pixel will light up - using WS2801 from ray

Discussion in 'RGB Lights - Intelligent Pixels and 3-Channel RGB' started by Daniel1973, Mar 17, 2015.

  1. Daniel1973

    Daniel1973 Apprentice Elf

    Joined:
    Dec 17, 2014
    Messages:
    70
    Likes Received:
    0
    Location:
    Mount Annan NSW
    ECG-P2 configure
     

    Attached Files:

  2. OP
    OP
    Daniel1973

    Daniel1973 Apprentice Elf

    Joined:
    Dec 17, 2014
    Messages:
    70
    Likes Received:
    0
    Location:
    Mount Annan NSW
    string and effect
     

    Attached Files:

  3. i13

    i13 Senior Elf

    Joined:
    Jul 5, 2013
    Messages:
    775
    Likes Received:
    6
    The effect configuration should not be blank.

    Try setting #01A to active, start at pixel 1 and set the pixel count to 150.

    Edit: Sorry for not picking up on the clock rate.
     
  4. OP
    OP
    Daniel1973

    Daniel1973 Apprentice Elf

    Joined:
    Dec 17, 2014
    Messages:
    70
    Likes Received:
    0
    Location:
    Mount Annan NSW
    thanks will try that.
    Also may have bad advice re- connecting up pixels. was connecting to rear of chip. not into chip
     

Share This Page