I was asked at the QLD mini if I could make a P10 panel tester. It would simply cycle colours so you can see if there are any bad LEDs.
I've written some new firmware for one of my boards that plugs straight into the P10 data input. The board is powered from the same 5V as the panel.
View: https://www.youtube.com/watch?v=J04B66nseyU
I've written some new firmware for one of my boards that plugs straight into the P10 data input. The board is powered from the same 5V as the panel.
View: https://www.youtube.com/watch?v=J04B66nseyU