P2 Error

Discussion in 'EthConGateway by Joshua 1 Systems' started by Lost sol, Dec 3, 2015.

  1. Lost sol

    Lost sol New Elf

    Joined:
    Aug 8, 2012
    Messages:
    32
    Likes Received:
    0
    Location:
    Bentonville, AR
    I hooked up a P2 today that have used the past few years and I am getting an error message I have never seen before. It says Error - Effect Pixel Start/End Out Of Range. Not sure what the issue is since I have used this P2 with no problems before. Can anyone shine a light on what this could be? Thanks
     
  2. ShellNZ

    ShellNZ Senior Elf

    Joined:
    Jun 17, 2012
    Messages:
    848
    Likes Received:
    1
    Location:
    Karaka, Auckland, NZ
    Find Me On:
    e.g you have 150 in the string config, but in the effects you have 151. Check your effects config against your string config :)
     
  3. OP
    OP
    Lost sol

    Lost sol New Elf

    Joined:
    Aug 8, 2012
    Messages:
    32
    Likes Received:
    0
    Location:
    Bentonville, AR
    That was it. I was off by one number in the effects. Thanks Shell!
     

Share This Page