1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

PixLite 16 pixel output pinouts

Discussion in 'Advatek Lights' started by BoonDogs, Mar 12, 2016.

  1. BoonDogs

    BoonDogs I am self diagnosed with CLAP

    Joined:
    Jan 7, 2016
    Messages:
    122
    Likes Received:
    0
    Location:
    Sydney
    Find Me On:
    G'day guys,
    I was wiring up the Ray Wu pigtails into the pixel outputs on my new PixLite 16 board. I can't seem to workout which direction the pinout goes, as the version printed on the board appears to be the opposite to the outputs I am using (1-4).
    Is the direction (left to right) +, CLK, DATA and GND, or GND, DATA, CLK and + for outputs 1-8?

    Noob question I know,
    Thanks in advanced
     
  2. Odd_Socks

    Odd_Socks New Elf

    Joined:
    Jan 16, 2016
    Messages:
    8
    Likes Received:
    0
    Location:
    Newcastle
    Hi,

    All the outputs have pin 1 marked.

    Outputs 1-8 are in fact the same way as the diagram on the board +,CLK,DATA,GND. That is if your looking at the board with the writing the right way up.
     
  3. OP
    OP
    BoonDogs

    BoonDogs I am self diagnosed with CLAP

    Joined:
    Jan 7, 2016
    Messages:
    122
    Likes Received:
    0
    Location:
    Sydney
    Find Me On:
    My eyes aren't great apparently, thanks for pointing that out.

    I just grabbed a multi meter and put it across the GND and + pins, and worked out the pinout that way.

    Now that I can workout the pinouts, it's burn in time.

    Thanks again!

    Riley
     

Share This Page