Ray Wu Null Pixels

Discussion in 'RGB Lights - Intelligent Pixels and 3-Channel RGB' started by AussieDoug, Jan 29, 2015.

  1. AussieDoug

    AussieDoug Full Time Elf

    Joined:
    Dec 1, 2012
    Messages:
    374
    Likes Received:
    0
  2. lizardking

    lizardking IT IS STILL ALL BENS FAULT

    Joined:
    Dec 26, 2014
    Messages:
    416
    Likes Received:
    0
    Location:
    Gold Coast
    Find Me On:
    these will be the next best thing he has done
     
  3. arw01

    arw01 Full Time Elf

    Joined:
    Dec 30, 2013
    Messages:
    384
    Likes Received:
    1
    Location:
    Eastern Washington
    Some new controllers coming out do away with the need for null pixels, but this could be a solution to a lot of peoples issues.


    Ray should post a photo and label the pin out at the connectors, not all of us would have used the same colors for the wires I'm sure as he did.


    Personally I used


    yellow/green strip for 12v
    blue is ground
    brown is data


    Alan
     
  4. mararunr

    mararunr Here to learn! (and share)

    Joined:
    Dec 31, 2013
    Messages:
    238
    Likes Received:
    0
    Location:
    3505 NW Edgewood Ave, Bentonville Arkansas, USA
    Find Me On:
    I think these could still be used for inline null pixels (long distance between elements). I have PixLite controllers which allow for null pixels at the start of a run, but I still have to put in my own inline null pixels where there's a long distance between elements/props on the same run (and then account for them in the set up of the sequencing software).
     

Share This Page