Ray's 3 pin connectors.

Discussion in 'Computers, Cabling & Other Miscellaneous Hardware' started by grahami2006, Oct 19, 2014.

  1. grahami2006

    grahami2006 Full Time Elf

    Joined:
    Jan 19, 2012
    Messages:
    196
    Likes Received:
    0
    Location:
    Bathurst NSW
    I need to make a cable from one 27 channel controller to the next with cat 5. I did have the set up but now have misplaced it.
    I need to know which wire on the connector goes with which wire on the cat 5. Obviously they would both have to be the same on each end.
    Thanks
    Graham
     
  2. AAH

    AAH I love blinky lights :) Community Project Designer

    Joined:
    Dec 27, 2010
    Messages:
    2,507
    Likes Received:
    1
    Location:
    Eaglehawk
    Find Me On:
    There's no "Ray Plug" standard that I know but if you're coming from the XLR Cannon plugs on the board then the info at http://auschristmaslighting.com/wiki/DMX_Adapter_Leads should be enough. The main this is the the dmx+ and dmx- must be on a paired cable fo the best results.
     

Share This Page