T splitter by ray wu - power injection

mborg10

Michael Borg
Joined
Dec 28, 2011
Messages
1,446
Location
claremont meadows
A few months ago I asked ray if he could make a t splitter for power injection. The data signal would go thru uninterrupted but the t part would allow positive and ground connection. I have some of rays prewired milky stars and this splitter could just plug in between.

Well here it is
http://m.aliexpress.com/item/1707253215.html?tracelog=storedetail2mobilesitedetail
He even used my diagram I drew for him.
 

mborg10

Michael Borg
Joined
Dec 28, 2011
Messages
1,446
Location
claremont meadows
These are the stars that I'm connecting. I have 100 of them.
http://m.aliexpress.com/item/1602954057.html
With the t splitter I only have to make power injection cable. The rest just screws together.
 

darylc

404 darylc not found
Joined
Dec 8, 2012
Messages
1,146
heathwithnoteeth said:
i assume i ignore the data bit on the T bit and just use the + / -

cheers

That is what I use to use them for power injection.

I don't see the value in special ones that don't have the 3rd pin - its easy enough to ignore it if you don't want it.
 

Habbosrus

Back again
Joined
Dec 5, 2012
Messages
758
Location
Swansea, NSW
heathwithnoteeth said:
i assume i ignore the data bit on the T bit and just use the + / -


cheers
Sorry mate, I probably should have expanded a little more. You're correct. Just make sure the data is terminated and doesn't touch either + or -
 
Top