teensy3.2 and octows2811 and FPP

morry

New elf
Joined
Jan 17, 2019
Messages
2
How to configure these to work with Xlights When I turn on pi and usb gets power leds plugged into octows2811 come on for a few seconds and then go off I know I flashed something on the teensy last year when I started this project but can't remember what it was any help much appreciated I upgraded FPP and I think it is just not configured right
 

franky_888

Apprentice elf
Joined
Dec 31, 2013
Messages
78
Location
Medowie
When I turn on pi and usb gets power leds plugged into octows2811 come on for a few seconds and then go off
In my experience this is caused by an under power condition. Do you have a large enough power source connected to the Pi?

Can't speak any further as to the teensy as it's not something I've used before.
 

morry

New elf
Joined
Jan 17, 2019
Messages
2
In my experience this is caused by an under power condition. Do you have a large enough power source connected to the Pi?

Can't speak any further as to the teensy as it's not something I've used before.
I did find out this is normal behavior what I'm missing is the header information when configuring the generic serial ports for the output channels in FPP can anyone help
 
Top