1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

Wiring and connectors for RGB Lights

Discussion in 'RGB Lights - Intelligent Pixels and 3-Channel RGB' started by jcdammeyer, Jun 2, 2015.

  1. jcdammeyer

    jcdammeyer New Elf

    Joined:
    Oct 12, 2011
    Messages:
    15
    Likes Received:
    0
    Ignore this request. I just found what I wanted on Ray Wu's site. He has lots of 4 pin connectors. One set of 5 pin connectors.

    Is there any sort of standard connector being used for the LED RGB addressable strips? Needed are 5V, CLK, DATA and GROUND so a minimum of 4 pins. Ideally 5 or 6 to pass a shield cable and perhaps an addressing IN/OUT signal.

    I've seen some white 4 pins out there on Alibaba but can't remember where now.
    thanks
    John
     
  2. DrNeutron

    DrNeutron Just starting in this crazy hobby

    Joined:
    Oct 19, 2012
    Messages:
    223
    Likes Received:
    1
    Location:
    Glace Bay
    Ok, 1st let me warn you that the information I am about to provide will possibly do these things:
    1. Lighten your wallet (definitely) ;)
    2. Increase your addiction to holiday lighting (absolutely) :D
    3. Possibly bring your family closer to you if they agree to become a part of your addiction (unlikely :'()
    4. Possibly cause a divorce if your wife does not understand or agree to become part of your addiction. ::)
    Ray is like a drug dealer of sorts, once you get hooked you can't get enough..... ;)
    http://www.aliexpress.com/store/group/13-5mm-series-white-waterproof-pigtails/701799_250410969.html
    Hey welcome to the madness fellow Canuck!
    8)
     

Share This Page