wiring set up Advatex 16 plug and play

Discussion in 'Advatek Lights' started by joemvela, Dec 12, 2014.

  1. joemvela

    joemvela New Elf

    Joined:
    Dec 12, 2014
    Messages:
    8
    Likes Received:
    0
    Ok guys I'm as new as they come, this is my first advatex controller, I was wondering if I could get a little help. I recently purchased a advatex 16 plug and play, I also got the male adapters, but I ordered the led strips from Ray Wu. So my question is can someone help me with with wires are to be joined together. I hope this isn't a dumb question, just want to do it right. ....where would the clock be attached to?......please help :)
    Advantek wire colors are :black -clock
    Red -12v
    White- ground
    Yellow -data
    Ray Wu setup was ( he emailed me this)
    DHL plug DC 12v+ and ground (extra power input)
    Red - DC 12v+
    Green - DAT
    Blue - ground
     
  2. adski

    adski Dave Brown

    Joined:
    Feb 15, 2012
    Messages:
    194
    Likes Received:
    1
    Location:
    Two Wells, SA
    Some pixel types require a clock signal, but other types don't - it looks like you have the latter type, so you can safely ignore the clock wire from the controller - just isolate it with a heatshrink tubing sleeve to avoid a short circuit.

    Dave
     
  3. OP
    OP
    joemvela

    joemvela New Elf

    Joined:
    Dec 12, 2014
    Messages:
    8
    Likes Received:
    0
    Awesome thanks adski, I really appreciate it. I'm nervous and excited about the pixlite/LOR journey.
     

Share This Page