coopz05
Apprentice elf
Im building my 2D mega tree frame tomorrow.
Im using a pixlite controller, but unfortunately they dont sell compatible strip.
Luke has advised me to get INK1003 strip.
When I look on Ray Wu it looks a lot more expensive than I budgeted for.
Does anyone has a link for some on Rays site that are reasonably priced but compatible with pixlite.
Pixels. RGB. INK1003. IP68.
Or has anyone else used another strip successfully? I really want to do text and even draw pics in the tree. Like stars a santa face etc
Ok, so my tree is like this;
5m pole
80cm in ground (concreted sleeve)
20cm to bottom of tree.
Bottom tree to top is 4m
Bottom is 225cm wide
Branches are 20mm conduit with strip glued and zipped to it.
I was originally planning for 16 branches. Now due to cost, I might downgrade.
My questions are;
Due to price, would 11 branches with 15-16cm spacing at the bottom be suffice to show clear text? Or is that too far apart?
Im leaning toward 11 cos of some letters like H, B, E etc that have a middle line
Also would 4m high with 225cm bottom be correct dimensions to look like a tree?
Thanks in advance.
Im using a pixlite controller, but unfortunately they dont sell compatible strip.
Luke has advised me to get INK1003 strip.
When I look on Ray Wu it looks a lot more expensive than I budgeted for.
Does anyone has a link for some on Rays site that are reasonably priced but compatible with pixlite.
Pixels. RGB. INK1003. IP68.
Or has anyone else used another strip successfully? I really want to do text and even draw pics in the tree. Like stars a santa face etc
Ok, so my tree is like this;
5m pole
80cm in ground (concreted sleeve)
20cm to bottom of tree.
Bottom tree to top is 4m
Bottom is 225cm wide
Branches are 20mm conduit with strip glued and zipped to it.
I was originally planning for 16 branches. Now due to cost, I might downgrade.
My questions are;
Due to price, would 11 branches with 15-16cm spacing at the bottom be suffice to show clear text? Or is that too far apart?
Im leaning toward 11 cos of some letters like H, B, E etc that have a middle line
Also would 4m high with 225cm bottom be correct dimensions to look like a tree?
Thanks in advance.