Interest Thread - RGB 12 LED 5050 Strip - Closing april 22nd

Status
Not open for further replies.
Re: Interest Thread - RGB 12 LED 5050 Strip

ChillOutDoc,

I was not considering the cool down speed. I guess carefully removing it from the griddle would be better if you can do it with out disturbing the chips. Or, hand solder them as you recommned. I guess the point is that SMD is NOT beyond the capbility of a DIY and there are many ways to "skin the cat". I sure like to watch everything flow all at once- it is a very cool experience.
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Capt,
I used both a griddle and a rework machine. I can fit 4 pcb's at a single time. I heat up the griddle to 350 F and then run the rework (hot air) 340 C across everything and within a couple minutes it’s done. I power off everything and I let the griddle temp cool off. I do pull the PCBs off the griddle before it's completely cold. I place them on a piece of wood to finish the cool down. While I get the other boards ready.
Dan
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Hi
I am interested in 25 PCB only

Thanks
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Put me down for 24 full kits and 1 solder tube, Thanks!
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Please put me down for the following:

Username: D56VillageNut
BOM 1 qty: 0
BOM 2 qty: 0
BOM 3 qty: 0
PCB qty: 50

Thank you.Alan T
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Hi Please put me down for

Username: DougieB
BOM 1 qty: 12
BOM 2 qty: 12
BOM 3 qty: 12
PCB qty: 12

solder paste 1
Thanks
Doug
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Put me down for the following;

Username: rewBOM 1 qty: 60BOM 2 qty: 60BOM 3 qty: 60PCB qty: 60Solder paste qty: 1

Thanks!
 
Re: Interest Thread - RGB 12 LED 5050 Strip

will get rest updated in the am. just wanted to post some updates.

the tube for the gb will fit the fast tubes and controller really nice. i should be able to fit 60 tubes in large flat rate box to aussies for about 65 bucks for the shipping. so the tubes are really cheap and look nice.
 
Re: Interest Thread - RGB 12 LED 5050 Strip

BOM1, 15
BOM2, 15
BOM3, 60
PCB, 15
1 solder paste


Also if possible due to the large number of tubes could you ship my box direct to me so save on the shipping from Eddy -> Me
 
Re: Interest Thread - RGB 12 LED 5050 Strip

Thinking about it now, Give us 30 Of Everything except the Tubes ill take 60 of them still. and maybe 2 solder pastes
 
Status
Not open for further replies.
Back
Top