Hello All,
I have a question regarding the channel setup on the pixlite 16. I am doing the outline of my house. I am using two power supplies so I am trying to put half the pixels on one side of the board and the other half on the other. My question is do i need to use all the outputs on each side? If I do not need to use all of them do you still have to assign the outputs not being used channels or can you just put 0 in the blanks? I think I may only need to use 2 outputs on each side, since each output will run 340 pixels. so I am a little confused on how to set that up inside the pixlite16 control panel. I know how to make it do all the same # of pixels per output and I know how to set it up for the outputs I am using. I guess I am just confused on how to tie in the outpu[/size]ts not being used.
[/size]
[/size]Thank you
[/size]Robin
I have a question regarding the channel setup on the pixlite 16. I am doing the outline of my house. I am using two power supplies so I am trying to put half the pixels on one side of the board and the other half on the other. My question is do i need to use all the outputs on each side? If I do not need to use all of them do you still have to assign the outputs not being used channels or can you just put 0 in the blanks? I think I may only need to use 2 outputs on each side, since each output will run 340 pixels. so I am a little confused on how to set that up inside the pixlite16 control panel. I know how to make it do all the same # of pixels per output and I know how to set it up for the outputs I am using. I guess I am just confused on how to tie in the outpu[/size]ts not being used.
[/size]
[/size]Thank you
[/size]Robin