Recent content by arowe1979

Yes I am trying to run the arduino over e131 wireless that is why i wanted to use the esp8266...also i am trying to control relays with the arduino to turn my 120 volt props on and off. I had a working sketch for the arduino bit it only works when hard wired into usb port.

Been trying to find a sketch for the arduino that can control relays from the mega2560...i need to it use the esp8266 so it can use e131 to control it from x lights.

is there any video or place I can go to get the exact way to set them up? in dpp it ask for a ip address and I am not sure what to put for it .. the show is ran through a pi 4 so the usb cables for the arduino is plugged into the pi.

I am having trouble setting up a arduino 2560. I used to use Vixen and have switched to xlights this year and I can not figure out what settings the controller should be at in the xlights page to make it function. the arduino was set up as a generic serial in vixen and it worked fine. can...