i am considering getting into using a projector with my other lights and i am try mapping software to make sure i understand it. Right now i have tried VPT-7 and HEAVY M my biggest problem is that i cant figure out how to save it in a format that can be played on the FPP. can someone explain how...
i got it figured out. i had everything setup correct the problem was where i plugged the crossover cable in. i had it plugged into the pixlite controller when it needed to be plugged into the LOR controller
i have used it for other things but not for this. do i have the lor controller and the pixlite hooked up together?
also is there any setting that need to change on the lor board to change it to dmx
devo i agree with you but is there a way to test that theory? is there any special lights that would blink when its sending a channel. on another thread fasteddy said with LOR controllers it must receive a constant signal so it doesnt go back to looking for the LOR signal does the pixlite do...
if i have a lor controller with unit id "05" that means that the dmx address is 65-80 that is how you would address the channels in the program correct. It would be universe 1 channel 65-80 . if this is right i have tried this and its not working. do you have to do anything to the controller?
bundyroy im not sequencing in LOR i am using vixen 3 i am just trying to us my LOR controllers in DMX mode so i can overall use E1.31 I tried the stuff you recommended but i am still doing something wrong i think it has to do with the dmx address. on my pixlite 16 i turned on all the dmx...
I have tried to set up the dmx outputs to run my LOR ctb16pc AC controllers i have not been successful yet anything you can suggget to help me out. i have the most up to date firmware. I dont understand when it asked for a universe number what do i put,then how does the LOR controller...
I am trying to do a zig zag effect with 2812 strips and wondered if it was possible to do that with the board or if it had to be done in the sequencing software? if on the board how do you do it?