Recent content by BAZMick

  1. B

    WLED/WT32-ETH01 Wiring Help

    Try to Wire the NE555 direct from the 12v to 5v converter, don't go through the middle wagon. I suspect the esp is getting 3.3v before the delayed 5v
  2. B

    Looking for Laser Cutting in Brisbane

    I start at 6pm and it's watchable, by 6:30 it starts to come to life. (Qld time) Brisbane's quite a fair way East
  3. B

    Looking for Laser Cutting in Brisbane

    Yeah I'm sure we can work something out. (Hint, I like JD) I've got "Karen" living next door to me so we shut the show down at 8pm this year, sorry about that
  4. B

    This year is just HoHoHoting me off!

    That'll do it. Back when we used to install office partition screens the specs say to keep data cable min 150mm away from mains. Or run in seperate conduit. And from personal experience I've had to re-route a data cable inside an industrial machine away from the mains supply to solve a gremlin...
  5. B

    Replacement Power Transformers

    I got some 31V 7.2W lightworx ones I'm not using, welcome to try them? They might be a bit less bright?
  6. B

    This year is just HoHoHoting me off!

    You didn't happen to move the mains cable next to and parallel with the network cable? The mains cable can induce voltage into the network cable and mess up the data signals
  7. B

    Unable to connect to Falcon behind FPP

    Have you set up the IP for the F16 in the FPP proxy settings?
  8. B

    pixels from one prop universe showing up on another prop universe in xlights

    In case our terminology is getting mixed up. 1 universe = 512 channels 1 RGB pixel = 3 channels 512 channels / 3 channels per pixel = 170.66 pixels 1 universe = 170x pixels = 510 channels. If you're setting universe 1 to port 1 on your controller and universe 2 to port 2 and setting 200x pixels...
  9. B

    Help required this weekend (Happy to pay) Brisbane

    I reckon it was more like a drop in the ocean, but thank you so much for the kind words and it was my absolute pleasure. I won't be able to come over with the other boys on Saturday but would you have it running Sunday? The Mrs and daughter want to see it after I showed them the photos. For...
  10. B

    Power tripping while show is static (no lights on)

    Not when at idle? Not a sparky but I encourage you to get one out to investigate. Something on that circuit that the RCD doesn't like
  11. B

    Help required this weekend (Happy to pay) Brisbane

    All good, what do you need me to bring? I'll have my tool boxes in the ute, and I'll bring some soldering gear and a step ladder. Anything else other than 35k pixels? My display hasn't got that many to begin with! And I'm 5V 😂
  12. B

    Help required this weekend (Happy to pay) Brisbane

    I should be able to come over for 6-7 hrs on Sunday. I'll check with the boss 😉 No payment necessary, happy to help where I can
Top