Recent content by chris19681986

  1. chris19681986

    First pixel comes on right away

    Problem solved. I put in my backup sd card. I must have changed some setting in fpp that screwed things up. Thank you. Btw. I have a k4-pb and a k16 a-b
  2. chris19681986

    First pixel comes on right away

    Problem solved. Put in my backup sd card and all is well. Must have changed something I shouldn't have in fpp. Thanks
  3. chris19681986

    First pixel comes on right away

    QUOTE] Mine stays even after running a small wave sequence or test sequence. During both it's not the right color
  4. chris19681986

    First pixel comes on right away

    Mine stays even after running a small wave sequence or test sequence. During both it's not the right color
  5. chris19681986

    First pixel comes on right away

    Make this as short as I can First pixel on each tower comes on when PSU is turned on. OR I should say as soon as the control card powers up. Each tower is 100 pixels Each tower is on a separate port Testing feature in fpp works but first pixel stays on when I turn testing off I have turned...
  6. chris19681986

    Kulp controller K4-PB

    I'll look at it when I get home. I wonder if you did a fresh install of fpp if that would help? Since it only takesx5-10 minutes.
  7. chris19681986

    Kulp controller K4-PB

    Unhook everything from your l8 except power and your wireless dongle. Power it in and wait for it do its thing. After a couple minutes go to your internet connections on your computer and you should see one that says fpp. Log into that one aame password as your regular internet. It will say no...
  8. chris19681986

    Kulp controller K4-PB

    I would go in fpp
  9. chris19681986

    Kulp controller K4-PB

    On my issue I tried but got no response. I just sent it back today with my receipt and note. Wait and see. Probably just ask for a refund or credit towards a card with ethernet and go that route. Already ran cat 6 to garage and a dedicated 20amp arc fault outlet. Plus if I get this all figured...
  10. chris19681986

    Kulp controller K4-PB

    Have you configured your ports in fpp? Nothing will happen unless you do that. You are one step further as I get no lights. It's totally dead. On it's way back to kulp.
  11. chris19681986

    Kulp board wont turn on

    Yes I thought that back then when I said it was scorching hot. I just ordered a pocket beagle from digi-key for 25.00. I have the board. Might as well use it. Thanks
  12. chris19681986

    Kulp board wont turn on

    Will not connect through ip address. When connected to usb port, I cant even get the blue power light to flash when power button is pushed. It will flash when connected to psu. Thinking it is dead and need to see if kulp will give me a replacement after 2 1/2 weeks or buy a new one. Thanks
  13. chris19681986

    Kulp board wont turn on

    All green lights are on(4) at the ports. Multimeter voltage at psu s 5.17. Same voltage at controller outputs. Only 1 pic from a week ago when it did work. Psu plugged into surge protector. Control card connected to psu, stood vertical to avoid heat build up. 1 3ft strip of 2812 lights...
Top