Recent content by CityMuseum

Under the network tab on FPP my settings are IP:192.168.10.2 NM: 255.255.255.0 No Gateway HinksPixPro static IP settings IP:192.168.10.1 NM: 255.255.255.255.0 No Gateway Still unable to achieve an ETH connection. I was under the impression that under the network tab on FPP, that IP was the IP...

Attached is what my setup looks like. The controller is going to be mounted in the center of a ferris wheel, so we need the FPP to be able to control the Hinks on it's own, preferably no router or other devices. We had a previous system with fpp and a hinks up there but it fell apart after 8...

I am still unable to get a test sequence to play, but with this setup below, I have regained the ETH0 icon on the FPP page and it says IP 192.168.10.1. My Tether IP next to it is 192.168.1 I have the Rasberry Pi hooked up to a second monitor and can see that its saying "My IP is 192.168.10.1"...

Here's my outputs, my current network config, hinks config, and proxy setting.

Quick Update. Shutdown FPP and Hinks when I left work yesterday, came back in turned it all on and the ETH works. Can send packets with no loss when Ping'n. Currently not able to get fseq files to play. They play, but no reaction from my lights

I have a Netgear N450 with 4 ethernet ports. Is this sufficent? When I had the Hinks and the Pi plugged into it at the same time is when I had the bouncing IP issues.

Howdy everyone. Setting up a HinksPixPro to run via FPP on a Rasberry Pi4 and having connection issues. With the settings in the attached photos, I was able to get an ethernet connection between the FPP and HinksPix, although I was unable to send any sequences over. I then set the HinksPix up...