Recent content by danno045

I was running a pretty basic show in player mode on my falcon f16v4 from an SD card. However, the SD slot came off the controller board so I need to find a different way to run the show. I have been trying to get things going through xSchedule. It recognizes my controller, but doesn't seem to be...

I wondered about that too, but when i did ipconfig on my computer on the same network it had the same subnet mask.

So is there something wrong with the controller setup to make FPP connect work?

I have always been able to connect to my controller through my laptop wirelessly with the FPP connect tool, but recently it hasn't been able to discover my Falcon F16v4 controller. I can ping the controller with my laptop and verified that it has a valid IP address. I am trying to remember if I...

Thanks for your reply. When connected indoors it shows the sequence playing on the status page. Yes I have xLights manage the outputs and use FPP connect. I will double check the outputs. Thanks.

I have tested the show on my lights in the garage and everything worked fine. Once I put the lights up outside, I unplugged the Falcon f16v4 and moved it outside to plug into the lights. I noticed that it doesn't connect to my wireless from outside so I brought the controller back inside to...

I just tried the V2 zlib option and believe they uploaded successfully as I see no error message, but I don't see the files on the controller under the file manager. Am I looking in the wrong place?

Is there a way to save a sequence specifically in that format? I see that option for the fpp connect tool, but not just generally saving and trying to upload via wifi.

I am getting this error when trying to upload a sequence to my controller. Any ideas for how to fix it would be much appreciated. Invalid FSEQ file: testSequence.fseq : Not a supported FSEQ format.