Recent content by dpitts

Hi, Sorry for the delays. I have only a few orders left to ship that were smaller orders for one of two pieces. I have sent an email to those customers expaining the delay. We are in process of shipping product to AUS so we can distribute locally. I have stopped orders from Australia until we...

Falcon Controllers and Accessories are now for sell at PixelController.com. Australians now have the option to purchase Falcon products at PixelController.com. Please note we need time to stock our Australian shipping location as product will ship via AUS Post from within Australia to keep...

Check the links here. FalconChristmas.com/f16v2 Sent from my LGLS990 using Tapatalk

Vixen 3 barely runs on a 3Ghz+ computer with 16Gigs of ram and the supported channel count for Vixen3 is extremely low with the best of desktop computers. It would not even begin to run off a 1GZ machine with 1 Gig memory even if the PI could run Windows which it cannot. You can put an Edimax...

The boards are shipping to Daryl and I next Tuesday.

Yeah. Thanks Daryl. I forgot to post here. Sorry :(

OK. You are good to go. Sorry for confusion. You did everything right. :)

Did you order the board from Falcon christmas.com

All US orders must be placed at PixelController.com/store. Please do not order from here if you are in Canada or USA only if you live in AUS or NZ. Just curious who told you the shipping was $14.00 from Australia to USA David Pitts

Yes. If the controllers are not hooked up disable them or unselect them in the E131 output section of FPP.

I ran my show for last two years without a hiccup. If you are running unicast to your controllers you need to make sure all controllers are powered and on the network or you will be brought down by ARP requests.

Your family is in my prayers Phil.

Nice. So you were the biggest sucker. :)

If these are DIYLEDExpress 2811 nodes it has been discovered that they do not like to be over powered at all. Please make sure the voltage is less than 11.8 volts. Your description of red glowing when no data was being sent is exactly what we found.

Have you disconnected the HDMI output. The PI I think will send out the HDMI if it detects a device connected to HDMI connector.