My Mistake 5 way 1/1/4" T 1 inch pipes are connected with reducers and center pole is 1 1/4" black pipe. originally had a 5 way 1" T but center pole on a 1 1/4 to 1 " reducer did not work well.
I am using this setup however (http://www.magicchristmas.org/uploads/3/4/6/9/34698654/asap_jr_.pdf) it is very windy where I am so I am using an 8ft diameter Bale feeder as the base and cut off the top portion (I will use the top for a spinner prop or similar round prop) on the bottom I am...
I am just starting out so have not made a final decision I have read pros and cons but have found so far that it seems to be working for me to just start out with.
Thank you for your reply. Running from XLights I encountered the same issue running wireless via a Raspberry PI/FPP. So I downloaded my sequences directly to the FPP and ran them no issue but I wanted to see them on a monitor. I also directly ran ethernet to my Falcon Controllers from a spare...
Fairly new to this and just wondering is there a way to Display Your Layout (Like when testing sequences in XLights) while running your sequences via XSchedule. I would like to be able to watch my scheduled sequences on a computer monitor if possible/ Sorry if this is a silly newbie queston.
Hello all.
Matt from Columbia Missouri. Fairly new to this of course. Just starting to build my display and show. I have been gathering hardware and software for the last year or so and experimenting off and on. Using Falcon controllers, PIs Xlights etc.. Will be putting up permanent roof...