Indigogyre's latest activity
-
Ended up putting the led channel under the gutter facing the street... Much better viewing And a hell of a lot easier to do the... -
Indigogyre replied to the thread Inserting pixels into ChromaBulbs.If it is not marked on the back I will take a contrasting sharpie and mark areas of importance for wiring. Maybe around the eyes and...
-
Indigogyre replied to the thread projection and practical props (lighting etc).Hello and welcome, I am not but can you describe what software you are using to map and control your current show? That would help...
-
Indigogyre replied to the thread Colour differences in imported sequences.Can you explain what you mean about off? There are many different interpretations that could be used. Remember, in an investigation...
-
Indigogyre replied to the thread My new install.Did you test in the dark to see how much light they put out?
-
Thought i'd start and show my install progress - Just keeping it pretty simple at the moment with permenant leds around the eaves of my...
-
Indigogyre replied to the thread Help.There is a dedicated forum spot for Baldrick controllers. https://auschristmaslighting.com/forums/baldrick-boards-by-ilightthat.84/...
-
I have fold up frames with 3D print clips to hold the tubes in 5 places, and those are held by steel garden posts (which I prefer to...
-
The arch over my driveway has 2 5m 12V 2811 strips on it and was rolled from 2 lengths of 30x30mm RHS. It's bolted to the railway line...
-
Indigogyre replied to the thread P4 panel build.So, how many panels is the matrix? 320 x 80 would seem to indicate 4 wide by 2 high but I do not think that is right. Normally a P4...
-
Indigogyre replied to the thread Need help with sequencing Locomotive & Cars (from Gilbert Engineering).I will not be much help since I do not sequence but since it is a train perhaps one of the polar express sequences might be a place to...
-
Indigogyre replied to the thread Xlights FPP Connect Issue.I noticed for the subnet mask you have it set to 255.255.252.0 where the typical subnet mask would be 255.255.255.0. Without knowing...
-
Ended up getting the TP link unmanaged for $89 which should do the trick for me.
-
Indigogyre replied to the thread Switch Recomendation.An alternative could be a similar Netgear switch. I alternate between the two brands depending on price at time of purchase.
-
Indigogyre replied to the thread Need help in Perth!.Are you asking about bullet pixels or led strips? There are different ways to go about it. Do you have a link to an example you are...
