I love lights. I have a few powerful flashlights that I was excited to get but every time I think about doing this light show I get excited.
Thank you for pointing me to the sequence for blinging lights.
I saw your videos and “WOW”. That is awesome!
Well since I’m thinking about going with half the pixels on a 180 degree mega tree. What would you suggest I do with an other 4000 pixels?
How many pixels do your small trees have. I did want to do about 6 to 8 of them eventually.
Also from where...
I’ve been thinking about your suggestion and I think you might be right. I do want to be able to see the tree from the front looking out but that might be something I will just have to deal with.
What do you think about going every inch instead of every 2 inches? How would 1” spacing look...
Where can you buy the pixel lights in bulk? The ones I found were about $2200 for 8000 lights.
I would prefer to buy bulk, I’m just not sure who to get them from.
What I’m trying to say is I’m a little ocd. Having a tree that is not 360 degrees would bother me. I’ve seen them done like that and it looks good, but I know it would bother me. Plus for the neighbors to see the whole tree it would need to be 280 degrees and I would rather just finish the full 360.
I’m sorry. I meant to say 360 degrees. That’s my fault. From the neighbors houses it would look flat and I don’t want to see the back of the tree from my house.
I see what you’re saying now. That’s only 5 more pixels per strand. That works for me.
So I could use a falcon f16v4 with an expansion board and run 64 strands with 3 strings each on 32 ports?
Did I get the terminology correct? Sorry I’m still learning all this.
Indigogyre, I just noticed you said nice car. That is actually a friends car that I did some work on for him. This is my car. Or I should say was my my car as I sold it recently. 9.00 seconds at 151 mph on pump gas. It was a daily driver for a while but it cost too much to drive and keep up...
I was looking at the falcon F16V4 tonight with the expansion ports. I was wondering about having the strand go up and then back down so instead of having to use 64 channels I would only need 32. But I don’t know if that would work. Or do I have to wire it differently?
I read that the falcon...
Yes I found a 1000 watt power supply that will work. I found that on another site that said I needed 8 350 watt. I checked the power requirements of the lights and 1000 will run them with a lot of room to spare.
I’ve been told I should start smaller but that’s not me. I have always been...