hi Danv I am after a couple of your Wixel PRO's with external antenna and your programmer are these currently available
I have looked at your shop and everything appears to be out of stock
thanks jeff
Use this app to test your config Then you can work out if is a Vixen issue
https://www.da-share.com/software/da_e131/
follow the link then download app
Also if you can not get the strip to work solder your data and clock lines to the next pixel You could have damaged the first pixel and when...
Steve I will be there
Great minds think a like. I was looking at have a Clap Day at my house, the boss gave me permission.
and I was try to workout how to setup.
I have a couple of thing that I can bring along for show and tell
Regards Jeff
I had upgraded my PixAD8 to the new bootloader and 2.7 of app software and have found that there must be a difference between the two process boards I have found
1 Self test causes pixel connected to output connectors 2,3,4,5 to flicker other output are ok
2 my sequences were not playing as...
I Have used a 12 volt sundown sensor with timer from a lighting shop they are used for path lights and they allow you to set how long they stay on after dark
I brought mine from bunning hardware store (australia)
Regards Jeff Rae
Guys as I said this was a quick and dirty solution to the problem
I use notepad ++ search ans replace to change unit ID and names.
Because I want to use the superstar instant sequencer to help shortcut my sequencing time.
I wrote a number of MSexcel vba routines to build props. I found a...
Here is a quick and dirty MSExcel2010 file that will convert lor unit nos to DMX only does universe one
No error checking is done
Just an exercise to show you how it could be achieved. Limited support available
Regards Jeff Rae
Once you have the UBL on your device you use the PC app to load the ECG firmware and yes you can install 2.7 with out loading all the previous revisions
Just remember to download the files for the ECG-P12 from the J1SYS site.
Regards Jeff
Here is a cheat sheet of how I upgraded my OLD PIXAD8 to the new bootloader and then installed the new app firmware
J1Sys has a video on the UBL23 pc app have a look at it before you start to instructions below
it will help you understand what is happening in the bootloader...
does he need a straight thru or crossover cable as he is connecting directly to his pc
you should be able to open a cmd window and use ping 10.10.10.10 and get a reply
Jeff