Recent content by Jon_101

Hi everyone, has anyone had any experience incorporating a 3d hologram fan in their display? And does anyone think that it's a good idea to do?

Strip waterproofing

Could you pls show it in a picture.

Video

Thanks Terry, definitely my +5v line is not connected to +12v line. For data threshold (I guess it's supposed to be 3.5v), and it shouldn't be a problem for under (7-9m) wire length, and I'm using f-amp for the longest branch (7+4m). For the common, should I connect to the v2 ground instead...

Thanks Mark, as you said I need to keep the wire less than 9m, and that is why I used f-amp for the (7+4m) branch.

Thanks Terry for your comments, power supplies wires are about 20cm each, 3 core wire will carry no voltage at all, just data. Sorry I didn't understand the last paragraph.

Hi everyone, is it possible to share ground with 2 ports? please see image attached. Thanks

Through trial and error, I found out that there was another way to make corners for strips without cutting and risking the waterproofing. What I did was I made a loop on each corner of around 10cm in length and assigned them to a group that declares them as null pixels which mean they will not...

Thanks for your answer, but even if you connect ground after the fuse,

Thanx, short answer is good :)

Hi all, is it possible to connect both grounds of power supplies together as shown in the attached photo?

Yes, you're right because video effect wasn't playing with the new version.

Wow, thanks a lot, error message disappeared.