Recent content by Kaite

Hi Guys, Just an Update on my original issue. I tried some off the suggestions in the thread to no avail. No matter what I tried, I was still having the same problem outlined in my original post. 1/3 of seeds working, Unplug the pigtail ( from PSU to Prop ), Plug pigtail back in, All seeds...

Thankyou for everyone advice. I will explore some of those points raised and report results back

Hi All, I have 4 x props made with seed pixels than run off 1 @ 360 W PSU Problem as follows 1. Run Sequence in Xlights. 2. Props 1 / 3 / 4 are working OK according to Sequence data. 3. Prop 2 has only about 1/3 of pixels working. 4. Unplug pigtail from PSU to Prop 2. 5. Re-plug pigtail back...

Thanks Skymaster, I will follow your advice.

Hi Johnnyboy, thanks for your response. Note - My electrical knowledge is very limited I use an Advatek Pixlite 16 controller. I use a 350 watt PSU to power up the controller. The 240 volt power shown in the original 2 methods is a separate power supply and does not connect to the controller

Hi All, could someone please confirm which of the 2 methods I have outlined in my sketch attached, is the correct wiring method for multiple Power Supply units. Apologies for the primitive electrical diagram.

Hi Merry, Thanks for you time. I deleted and reloaded latest update of xlights and problem is resolved. Obviously a glitch in the loading process.. Technology is Great... until its not Great !!

Hi Merry, Thanks for your response. Xlights version is 2026.25. I updated xlights version when I transferred all data to new laptop. Could you elaborate on what you mean by " how did I open it ", ( other than what the normal procedure is ! ) Also , how would I establish if it is " open read only...

Hi All, Recently moved everything to new laptop. Unfortunately everything in the Controller Tab has now frozen. Red Dot is on, but I cannot make any changes to the details shown to Save. Any help would be appreciated.

Thankyou, you were quite right. It has not affected the testing performance. I just was concerned there may be a fault in the board.

Hi, I am running 2 x Pixlite 16 Controllers. Controller 2 - Pixlite 16 / V 3.6 Controller 3 - Pixlite 16 / M II / V 1.1 When in Test Mode , Controller 2 has the "All Outputs " line Ghosted out. Controller 3 is OK Can someone explain. Sorry about photo. My screenshot not working.

Thanks

sorry if this is a basic question, but how do i tell my pixlite 16 that i only want 1 output to be RGBW, and all the other outputs to be RGB ?

thanks for that

Thanks for reply. Can you utilise both 3 channel and 4 channel in Xlights at the same time ? is there a site that outlines this process. I have an Advatek Pixlite 16 controller