Recent content by Loveinthebay

So... basically started a new sequence and now the back lights work? Perhaps in my existing show that was running during Halloween there is something going on that I cant quite put my finger ok. That should be easy enough to make new sequences and copy things over. @Pavle @Skymaster Thanks so...

Plugged into a differential expansion board (probably don’t need to use this right now in retrospect), that is plugged via ribbon cable. rotary dial on srx2 is set to “0”. I can actually try to go straight into the f16 board and omit the differential receiver for now to see if that resolved...

Basically I will use the " upload output" from the controller tab when i make changes to channels and models. After i do this, i do see the updated models on the correct channels in the falcon web app. I have also ran the "FPP connect" to upload my sequence to FPP but same result i.e. not...

To add onto this thread, perhaps folks may be able to glean some light. I have a falcon f16v4 powering my front yard show. I have a diff controller connected to the f16v4, running a cat6 cable to a box in my backyard (less than 250 feet) that has a srx2 Channels are the following for the srx2...