No1Daemon's latest activity
-
NNo1Daemon replied to the thread Another power injection question.Quick update. I was unlucky enough that my Mac suffered some sort of error which bricked it. Had it to the techs and they got it going...
-
NNo1Daemon replied to the thread Another power injection question.Resistance is about 1 to 1.2 between input and output ground. Perhaps I'll get my proper controller out and set it up.
-
NNo1Daemon replied to the thread Another power injection question.I will check that tomorrow and see. I will switch out to some better wire also and see if there's any difference. Thanks
-
NNo1Daemon replied to the thread Another power injection question.Yes. That's the same as what I was trying to say above. Thankyou. It's easier when you can see it
-
NI've drawn up two different power injections that will work depending on if you are using the same power supply, or if you are using...
-
NNo1Daemon replied to the thread Another power injection question.I have attached a few photos. Photo 1 is the controller Photo 2 is the power supply. It's generic and not the greatest wire but it's...
-
-
NNo1Daemon replied to the thread Another power injection question.Each time I have wired it and failed I've started again. I will wire it up again and take some photos. Appreciate the advice
-
NNo1Daemon replied to the thread Another power injection question.Hi Mark. Thanks for the reply. They are 3 wire seed pixels. I have had similar results with my regulated DC power supply and 2...
-
NNo1Daemon replied to the thread Another power injection question.Good point. I never thought I needed to but I'll double check from now
-
NNo1Daemon replied to the thread Another power injection question.Just in the process of checking what I can still. The PSU are both the same voltage. The new test strings work fine. But I haven't yet...
-
NNo1Daemon replied to the thread Another power injection question.I am just using an SP105E controller currently.
-
NNo1Daemon replied to the thread Another power injection question.Hi. Sorry you are correct. It isn't very descriptive. Looks like it shorted somehow. I have had to remive some leds and have made a...
-
NNo1Daemon replied to the thread Another power injection question.Hi Sorry I edited that. There is no second controller, that should have said "second power supply" The tee is connected after the 1st...
-
NNo1Daemon posted the thread Another power injection question in RGB lights - Intelligent pixels and 3-channel RGB.Hi guys. I know these get asked a lot but I am having difficulty and could use some advice. I didn't have any power injection tees on...
-
