That sounds like exactly what I need ;D
Have you an estimate on when you will receive & start testing your prototype? If you need an overseas tester, I will volunteer!!
Can you PM me when you are able to quote prices or start shipping.
OK.
So correct me if I'm wrong, but the setup/operation would be;
I have an output from my P12 which is connected to your board. The P12 will see your board as 15 channels/5 pixels. I then connect you board to a dumb strings (3 channels)?
Am I correct in thinking then that there are 12 other...
How many pixels/channels could it drive?
Obviously dumb strip would only be 3 channels, so a 30 channel controller could in theory drive 10 strips. However, the same channel count would only drive 10 pixels of intelligent strip? I think I may be missing something obvious here?
I have a J1Sys...
Thanks Al
I just posted a reply on another board asking for some more info on your controllers!!
I was hoping to use my J1Sys board for everything, but have since found out it only works on adressable strip. I don't really mind as it gives me extra capacity for the future- I am only planning a...
Hi folks,
I am in the process of gathering components for my display this year, & have aquired different RGB DC strips at different voltages.
I am using LOR S3, so think the LOR controller will be best for dumb strips (I have a J1Sys board for my 3 wire addressable strips).
I have 3...