*UPDATE*
I was able to successfully configure XLIGHTS to read and use my old LOR configuration. I used the "Add LOR" option in the network and I used the wizard to add all my current LOR controllers that exist in my show. Doing so put me right at 128 channels which is what was needed for the...
**UPDATE**
Iv finally been able to solve my issue by once again changing the strand value to 2. I think what went differently this time to allow it to work is the fact that i'm back on V64. Not entirely sure but, here are the results;
Original 16 Strand, 50pixel Rendering...
UPDATE:
I was able to fix the dupe issue by falling back on V64, the issue I have now is the sequence only displaying on half the tree instead of all 100pixels. Rendering did nothing, tried to export the effects via .avi then use the video effect on the model...
Hello, I was hoping to get some assistance with rendering extra pixels into a sequence iv purchased. Long story short, we been using a 16 strand, 50 pixel rgb megatree and decided to upgrade to a 100pixel node run tree.
The problem iv run into is, upon updating my pixels from 50 to 100 in the...