On doing a bit more digging, I think my panels are 1/4 scan which doesn't appear to be supported by the Pi and Adafruit controller.
I have a Beaglebone Black and have an octoscroller on order but it will take a while to come and I would like to confirm the cause of the problems If it is the...
Can anyone give me any pointers to where my problem lies.
I have a 32 x 16 RGB panel connected to a Pi 3+ via an Adafruit Bonnet.
In Xlights I have only the Matrix configured
Setup:
Number: 1
Network: Null
Universe: 64001
No. of Channels: 1536
xLights Mapping: Channels 1 to 1536
Active: Yes...