Plus side it gives me a week or so to finish setting up the displays, while waiting on board to arrive. I am super excited to do it, finally got wifes permission, been trying for 6 years lol. Again thank you everyone.
THANK YOU everyone for the suggestions. I just spoke with David. He is sending a replacement board. Somehow my board shorted. The resister on the right of the board was extremely hot
I do not have a 5v psu, everything i went with are 12v. The only cables attached to board are the power on v1 and v2. I did pull the fuse by v2 and checked there and it also gets 12v
Ok here is backside of board, and the top of board with all wires disconnected. As you can see on back of board, it is on lexan. Along with spacers holding it off of theblexan. Again ALL power inputs on the board is showing 12v and the power switch is set to 12v not ext
So it would appear...
I will have a look at that switch tomorrow. I am almost positive it is on 12v, all of the led's are lit up along the bottom for the outputs and on both the v1 and v2.
I emailed, used online form and tried to call dpitts. I am sure he is super swamped. I am hoping he has an idea as to what could he wrong. Just my luck tho, first year after finally having wife go ahead and then bam lol
I am in Illinois, and wife finally gave me permission and the go ahead to run pixels.
So, for my first year, i have 2000 pixels, 4 30amp 360w power supplies, falcon f16v3 , 2 power distro boards and a Raspberry pi 4b, all packed nice and neat in my control setup.
I am outlining my house, and...
Ok so anyone have any idea could be wrong? I hooked my f16v3 up so I could test lights, and the oled wont come on, the 2 led liights arent lit up either. I tried to reset the board, but no dice
I had to replace a fuse on the power input but dont know why. My psu's are all running the...