Recent content by zoobmarine

Yeah, I figured out, the controller just supports multicast, that was why.!

Hi to all, I recently bought the following E1.31 controller from Ray https://www.aliexpress.com/item/E1-31-sACN-to-4-DMX-Interface-support-Madrix-software/32466094111.html?spm=2114.13010608.0.0.nOxQSn I tested with dae1.31 software in multicast and works perfectly, when I set it up under...

Also dont forget you can go to the Chat

Just like AHH Mentioned you need to change the Universe size to 510 on FPP

Hi Tooms, some screenshots of your configuration might be helpful

I think that the CG-1500 enclosure will be enough for this

Wow, that is a large question, I really suggest you hurry up and consider ordering fast, next week there will be Holidays in China, so they will have some days off, you must considers also this because of the delays that you may expect.

Thanks David, so the easiest way would be LOR? Or can you point me to a option that is not DIY? Thank you

Hi, I saw this controller it is a DMX Decoder Relay, I need your help, I saw the connection diagram and I noticed that it shows 110VAC as output, the question is, do you think this controller could work with 110VAC christmas lights? Like a LOR Controller? Thank you...

Has anyone had luck contacting ED?

Now I get it, it would be like in the movies, which cable should I cut..

3 (3 cables) set? is that what I noticed?

Well it is a hard work, good luck, thanks for sharing, would like to see the sign finished!

If you are going to use nodes I suggest you use 2 sheets of coro, this will keep the node in place always, I used a pencil soldering iron to make holes was very easy, and after heating y placed the node the warm of the hole make it easier to place the node, when it got cold it fixed very good

What material did you use? Did you use a CNC for drilling?