Ready to run controller to run controller

Hi I was given 8 single 10W RGB Flood Lights, that had been purchased from the light o rama store. What ready-to-run controller will I need to purchase? They have 4 pin ends, and I would like to sequence these into my current Xlight show. I this even possible? any suggestions is greatly appreciated.

I presume you mean these Light-O-Rama 12V DC RGB flood lights. The light is what we typically refer to as 'dumb RGB', in that they don't have any smarts in them to make the lights addressable. Dumb RGB lights run off of a low voltage DC controller, such as those listed in our wiki or 101 manual. You'll need to supply 12V DC to the DC controller, as the flood lights you have are 12V DC.

One of the four pins will be V+ (12V) and then the remaining 3 pins will be one for Red (R), one for Green (G) and the last for Blue (B). I'm not sure what order this will be in. The colour of the wire may not match the colour or the LED.

OMG that is them exactly, I will look for a ready run controller. Definitely not up to the electronic part of lighting just yet.