…debugging

Hi All.

Dont you just hate debugging your setup.

I had my (very small, around 1000px) Arduino setup all working inside, moved it outside, set it all up, and now it doesn’t work!

Turns out my 1c jumper cable broke, and I have to de-solder around 5 connections to get it out…

Is their an easier way?

Thanks,
Dino.

(Ps, sorry if this is the wrong forum)

1c is 1 cent?
A single broken wire is often enough to take down large parts of a display.

AAH said:

A single broken wire is often enough to take down large parts of a display.

Click to expand...

Especially the one from the power pole to your house

Haha yes!
Was testing last night and found the first 2 pixels on my matrix weren’t lighting up through FPP, but were fine with Baldrick test.
Long story short, had the wrong start channel set on the Baldrick.. forgot to upload output

Troubleshooting is always fun, but every year I get a little better at it!

Yeah… and probably trying to run around 1000 px in generic serial is stressing my Arduinos…