Configuring floods

Yep. Did the render, upload. And yes, the location of my receiver is to the right of all my floods, but I like to number from left to right. So, connected 3 to receiver and then 2 to 3. Maybe I'll go into the zoom room and see if someone can figure it out. Thanks for your efforts! I'm a little stumped on this one.
 
merryoncherry said:
Only thing is you said "receiver" ... by the visualizer you have this in "dumb" mode, it is not in smart receiver mode, right?
Click to expand...
Yes. I believe that’s correct. I have two falcon receivers that are both connected directly to the falcon. No chaining. Other receiver works just fine and the three other ports on the trouble receiver work fine as well. Just having the issues with the two floods on the one port.
 
The existence of a chain doesn't control it, the little dial on the receiver board does. In your visualizer diagram, the one with the green A seems set up as smart, the other does not... Just an easy thing to check that is a known source of confusion.
 
Ok. I’ll have to take a look. Should I put it in smart mode then? Could that be the issue?
 
I'm just saying make sure they match xLights. If you want only one receiver per port, no chains, dumb receiver mode is a great choice. Set that way in xLights, set the dial, you'll not have to worry about that maybe being the issue.
 
Ok. I made the receiver match xlights. Made it smart mode just to match the other receiver. Both are now smart. Didn't fix the issue but it needed to be done. However.....good news....I believe I found the issue. When I clicked on the Flood light models in XLIGHTS, I found that either flood 2 or 3, I don't remember had "set color order" clicked. The other two floods did not. I unclicked it, saved layout and the uploaded to controller. Seems to be working correctly with just simple testing!!! Guess I'll find out when I put some real sequences on it! Thanks for your help!!!!
 
You must log in or register to reply here.
Back
Top